xbox 360 Ring of Death Reballing R600

 FOR ALL VERSION xBOX 360′ and Xbox slim -  FREE QUOTE.

FREE Return Shipping Via SAPO Normal Post ONLY (with insurance - SAPO T’s & C’s apply) only if quote is accepted. Throughout South Africa – to your nearest Post Office. You are also welcome to use your own courier service however your own arrangements and payments will need to be made.

ONSITE REPAIRS – QUALIFIED AND PROFESSIONAL TECHNICIANS

WARRANTIED REPAIRS :  MAJOR AND MINOR REPAIRS

XBOX 360  RED RING OF DEATH (RROD) 3 FLASHING RED LIGHTS  ARRANGEMENTS CAN BE MADE FOR SAME DAY REPAIR!  

Xbox 360 lasers

Xbox 360 – E74 error

Xbox 360 tray repair

Xbox 360 laser + tray repair

 Xbox 360 “FREEZES” repair

Xbox 360 not synchronising with remote

Xbox 360 Network port repair

All repairs are subject to FREE QUOTES prior to Warrantied Onsite Repairs. Inspection needs to take place by our Onsite Qualified Technicians First, before any Free quote may be given.

Xbox 360 Red Ring of Death (RROD) 3 flashing red lights: Red Ring of Death or 3 flashing red lights happens when you try to switch on your Xbox 360 and 3 flashing red lights will appear. Regardless if you switch the unit on and off the 3 red lights will keep appearing. Some units will go to game play, however this problem will only get worse and eventually the unit will permanently flash 3 red lights and will not switch on.

causes:  The GPU (Graphics Processor Unit) is a BGA chip. The tiny micro lead balls that connect the GPU to the main motherboard dislodge themselves, become corroded, melt and cause a “dead short”. This in turn causes the machine to malfunction which is as a result of the above RROD.

Due to usage and playing of the console, the bga and motherboard heat and cool. This process causes microscopic cracks in the solder balls, not seen with the naked eye.  These in turn cause the unit to malfunction and therefore RROD

. 

How to fix RROD: The unit is stripped, cleaned and sent to an electronics laboratory. Controlled heat is used to remove the GPU, clean the solder on the GPU and main board, reball with new solder balls and reapply the GPU to main board. Main board is now inspected with an Xray machine. It allows for inspection of each solder ball, possible cracks and “champagne bubbles”. Now that the unit has been inspected and approved, the unit is sent back to the repair centre to be assembled and tested