Main centres: | 1-3 business days |
Regional areas: | 3-4 business days |
Remote areas: | 3-5 business days |
2 x 1,000 Watts into 2 Ohms; 2 x 750 Watts into 4 Ohms; 2,000 Watts into 4 Ohms (bridge mode)
ATR (Accelerated Transient Response) technology for ultimate punch and clarity
Switchable limiters offer maximum output level with reliable overload protection
Detented gain controls for precise setting and matching of sensitivity
Precise Power, Signal and Clip LEDs to monitor performance
XLR and 1/4″ TRS input connectors for compatibility with any source
Professional speaker connectors and “touch-proof” binding posts support most speaker wiring systems
Selectable low-frequency filters remove damaging infra-sound frequencies
Independent DC and thermal overload protection on each channel automatically protects amplifier and speakers
High-current toroidal transformer for ultra-high transient response and absolute reliability
“Back-to-front” ventilation system including air filter for reliable operation
“Built-like-a-tank,” impact-resistant, all-steel 2U rackmount chassis
High-quality components and exceptionally rugged construction ensure long life
Conceived and designed by BEHRINGER Germany
Panel discussion
A panel of switches found on the back panel offers an array of cool options to apply to both channels of the EP2000 and EP4000. The Clip Limiter lets you get even more out of the amplifier without overdriving either it or your speaker system. Built-in circuitry automatically senses when the EP2000 or EP4000 is being overdriven into “clipping” and then momentarily reduces the input level to avoid clipping distortion. Since this all happens in just a few thousandths of a second, it’s the ideal way to avoid audible clipping distortion.
Rickety stage vibrations, mic thumps and wind noise can cause ultra-low frequency sounds, or infrasonics. While technically inaudible, they can cause a huge drain on amp power, potential damage to your speakers and a sludgy sound in the audible bass ranges. Both EP models feature a defeatable Low Cut Filter that chops off unwanted frequencies below 50 Hz or 30 Hz (depending on your PA system’s capabilities).
The same panel contains the switches that put these amps to work in either Stereo or Bridge (mono) mode. Both the EP2000 and EP4000 can be linked to additional power amps by switching into Parallel mode.