Main centres: | 1-3 business days |
Regional areas: | 3-4 business days |
Remote areas: | 3-5 business days |
Print the pattern you want to
use. Place your fabric on a
hard, flat surface. Place the
printed pattern on the fabric -
pin or tape in place.
Cut the Transfer Film slightly larger
than the design. Peel off white
backing. Place film sticky side up
over pattern and tape corners.
Pick up each rhinestone
and place it over each dot
in the design
Continue placing rhinestones
until design is completed.
Replace any colors that
are in the wrong place
Lift Clear Transfer Film with
design off the paper pattern.
Place completed design
exactly where you want it
on your garment. The sticky
film will hold it in place.
Preheat DRY iron to temp
for your fabric. Place iron on
top of film - lift and move as
necessary to heat entire
design evenly. Allow
15 - 20 seconds for 3mm
or 4mm rhinestones (more
time for larger rhinestones).
Cool to touch then slowly
peel off transfer film. If any
rhinestones are still on the
film, cut away film where
rhinestones are secure and
replace on just the area
of film where the stones did
not adhere - repress for
8 - 10 seconds.
Completed transfer motif.
To wash, turn garment
inside out and wash on
gentle cycle or dry clean.
Add additional rhinestones
with the BeJeweler
if desired.