| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
This is the new version with 2 large holes in the sides of the head to allow for better e-liquid saturation. This version also fits the Atlantis 1 Upgraded Tank and Atlantis 2 Tank
This item also fits:
It can be rebuilt using Kanthal A1 Wire as at Kanthal 28AWG Wire, Kanthal 26AWG Wire or Kanthal 24AWG Wire to reach resistances from 0.3Ohm to 1.2 Ohm for the optimized vaping experience.
100% Japanese organic cotton sheets can be found here
To assist in rebuilding your coil use the RDA / RBA Deck Toolkit and 30-in-1 Screwdriver Toolkit Set
Ni200 Wire as at Ni201 Zero Resistance Pure Nickel Wire can also be used to reach as low as 0.10 Ohm but please note a Temperature controlled MOD such as EVIC VT needs to be used for Ni201 Coils or mechanical mods capable of firing Ni200 Zero resistance coils.
Warning: This is a sub-ohm resistance item as is. It will only work on a mechanical mod with a battery capable of 20 watt or higher or a VV/VW mod capable of 20 watt or higher. You must be sure that your mod AND batteries can handle SUB OHM coils. If you're using an electronic mod, make sure it and the battery you use (if removable) can handle the amps. For mechanical mod users, please use 30 Amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe!
Please keep in mind this is a rebuildable item, so this purchase are for the RDA only, not the parts which is mentioned above, if they do not work for you out of the box at the rated ohms, rebuild the coil with your own supplies. That is what an RDA is for. We cannot return it for any issue with the included cotton or coil. It's replaceble and rebuildable.
