Main centres: | 1-3 business days |
Regional areas: | 3-4 business days |
Remote areas: | 3-5 business days |
The HDMI Extender over Single Cat5e/6 with IR extends high definition video and audio signals and IR, at a distance of up to 50m (1080p) / 90m (720p) over a single Cat5e/6 cable. Features EDID management, which allows and the source and display ¿Handshake¿ for seamless integration with only one cost effective Cat5e/6 cable. In addition, the extender is also equipped with pass-through which allows for source control.
Package Contents
Features
Specfications
Transmitter Unit
Receiver Unit
RX Equalizer Distance
If you see flickering or a sparkling image on the display, adjust the EQ switch to improve the cable skew. MAX stands for the strongest HDMI signal level while MIN stands for the weakest HDMI signal level for short transmission.
Connection diagram
Connect and Operate
If a display is having difficulty receiving a signal, see EDID section and perform EDID learning or access the display's menu and adjust the resolution (lowest to highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the source remote at the receiver emitter to test IR functionality. If the IR remote function is not responding, check the emitters to ensure they are placed correctly and are plugged into the correct IR jacks on the Extender set receiving and transmitting units.
Wideband IR(30KHz---60KHz) introduction
TX IR: To control the source: Plug the IR Blaster into IR TX port of the transmitter unit and place blaster in front of the IR eye of the source.
RX IR: To control the source: Plug IR Receiver into IR RX port of receiver unit and place receiver at or near display.