You are looking at the Nady EO3, which consists of one wireless transmitter (E03-T) and bodypack receiver (E03-R) and 1 pair of in ear monitors, is one of the greatest in ear monitor systems on the market! The transmitter features eight factory switch able channels, and will not interfere with any VHF or UHF mics on stage. The E03 system has a wireless operating range of 300 feet which allows it to be used with line out from any mixing console, and broadcasts the audio as an FM signal to any number of pocket size Nady E03 receivers on the same channel. Each receiver is equipped with an adjustable volume control, and high performance earbuds. The transmitter also provides a microphone input to allow wireless cueing of the performers on stage.The E03 can provide a high quality monitor mix at significantly lower decibel levels than floor monitors. This is an important benefit for artists who wish to protect their hearing from excessive and potentially damaging sound pressure levels.If you want quality, than go with this Nady product. Nady has been delivering the best deals and has been the most trusted pro audio brand for assistive listening devices for over 20 years, and this deal is un-beatable! If you want performance and reliability, than this product is a good choice for you.Includes: - earbud monitors
- Bodypack Transmitter
- Receiver
- Wiring, so you can set-up right out of the box
- Instructions
- Warranty
Features - High-quality monitor mix with wireless freedom anywhere on stage
- Up to 300 ft range, line of sight
- Operate up to 4 systems at a time and on special frequencies that wont interfere with other wireless mics on stage with 8 different channels to choose from
- Pair of mini binaural earphones included with each bodypack receiver
- Compact transmitter that broadcasts on one of eight channels in the 72-76 MHz band, to any number of Nady E03 wireless bodypack receivers on the same channel
- Huge 300 foot. wireless operating range
- Eight factory switch able channels
- Rear panel input for line level audio
- Front panel input for microphone
- Audio input gain control
- Automatic level control
- Extendible antenna
- 9 volt DC input for AC-EO3 9VDC regulated power supply adapter provided
- Power switch with red LED power on indicator
- Audio modulation LED indicator
- Frequency Response: 100 Hz - 10KHz 3 dB
- Signal to Noise Ratio: 60 dB
- Total Harmonic Dist.: < 0.5%
- RF Carrier Frequencies: Eight factory preset channels between 72-76 MHz.
- Channel AA: 72.1, BB: 72.3, CC: 72.5, DD: 72.7, EE: 72.9, FF: 75.5, GG: 75.7, HH: 75.9
- Frequency Stability: Better than .005%
- Modulation: M 75 KHz
- Operating Range: Up to 300 feet line of sight
- Line Input: Connector: One 1/4 phone jack. Impedance: 100 K Ohms, unbalanced.
- Mic Input: Connector: One 1/4 phone jack. Impedance: low impedance, unbalanced, with 9 VDC
at 1 mA for condenser mic. - Power Output: 80,000 V @ 3 meters
- Controls: Power On/Off, audio input gain adjust
- Indicators: Power On LED, Audio Modulation TX LED
- Antenna: Permanently mounted telescoping whip
- Power Requirement: 9 VDC regulated, @ 200 mA, AC-EO3 adapter provided
- Dimensions: 1.25" H, 8.25" W, 4.25" D (3.175 x 20.9 x 10.8 cm)
- Controls: Combination volume/on-off wheel
- Audio Output: 100 mW max into 16 Ohms
- Connectors: 3.5 mm mini jack for earbuds output
- Earphones: Binaural EB-3 earbuds
- Antenna: Integral with earbud cord
- Indicators: LED power on indicator
- Sensitivity: 2 V for 12 dB Sinad with squelch defeated. Squelches at 10 V for min. 50 dB S-N ratio
- Mute Threshold: 8-10 V
- Power Requirement: 9V carbon zinc or alkaline battery
- Battery Life: 17-20 hours with alkaline battery; 10-12 hours with carbon zinc battery
- Dimensions or receiver: 3.35 H, 2.75 W, .75 D (8.5 x 6.5 x 2.25 cm)
|
