This item has closed with no items sold
View other items offered by AutoStop0134

Similar products

R30 shipping
Ford 1054420 - Mass Air Flow Sensor
R759
R30 shipping
Audi 0280217529 - Mass Air Flow Sensor
R946
R30 shipping
Volvo 30611533 - Mass Air Flow Sensor
R1,095
R30 shipping
Audi 0281002757 - Mass Air Flow Sensor
R946

Airflowmeter Mass Sensor Cleaner

New
R199.00
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer Protection How you're covered
Get it now, pay later

Product information

Condition:
New
Location:
South Africa
Product code:
Cr100
Bob Shop ID:
236967693

 

Mass Air Flow Cleaner

Clean your MAF sensor every time you change your Air filter

Airflowmeters Mass Sensors cost a fortune it is best to have them clean before buying

This spray can be use on all sensors in your vehicle and all electrical plugs, its a dry quick application

Don’t use aggressive chemicals like Brake Cleaner or carburetor cleaners on Mass Air Flow sensors. These can cause serious damage to sensitive parts. Use CRC Mass Air Flow Sensor Cleaner is — It’s the right product for the job! It safely and easily cleans the Mass Air Flow hotwires and electrical components without damage to the wires or plastic housing. Cleaning is simple, safe and fast. The whole job should take less than 10 minutes!

Perfect for cars that have had “over-oiled” performance filters installed. Over-oiling can cause the HFM to gum up, this is the perfect solution.crc

HOW TO CLEAN YOUR SENSORS PLEASE READ BELOW

Cleaning your MAF sensor is easy and should take about 10 minutes. First, turn off your vehicle and locate the MAF sensor between the air box and throttle body.  Unplug the MAF sensor wire harness and remove the MAF sensor housing. Typically a screwdriver will work, but you may need a TORX® security bit for some models.  Place a shop towel under your MAF sensor to catch any run-off.  With the straw attached, apply 10-15 sprays of CRC MAF Sensor Cleaner onto the hot-wires, but be sure the hot-wires do not come in contact with the straw or any other object.

Spray all sides of the MAF sensor and clean all wires and connectors.  Finally, reassemble the MAF sensor and allow it to dry thoroughly before restarting the engine.  This would be a great time to clean or change your air filter, too.

 

We do deliveries all over the country Aramex door to door or post office counter